C and CFR Variety Effectiveness Information

C Form Flex-Flex Couplings
The C Type coupling includes two flex hubs, one particular sleeve and 1 accessory kit consisting of seals and snap rings.
CFR Type Flex-Rigid Couplings
The CFR Type coupling include 1 flex hub, one rigid hub, a single sleeve, one accessory kit consisting of seals and snap rings.
Characteristics
Uncomplicated and economical style of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in area
Accessible as vertical and horizontal couplings
Broad selection of exclusive variations which include full-flex, flex-rigid mill motor
Conventional configurations are available with the shelf
Ordering Information
Application: Driver and Driven.
Variety and dimension of coupling, horizontal, vertical and so forth.
Energy: Motor horspower or torque requirement.
Pace: Motor RPM or Driven RPM.
Distance among shaft ends (BSE).
Shaft sizes.
C and CFR Kind Couplings
Ordering Details
Puller Holes are standard on sizes 4 through twelve.
Puller Holes can be found for sizes 7/8 as a result of 3.5 at an additional charge.
The BSE (distance In between Shaft Ends) may well vary concerning G and G1.
Interference bores without any set screws are regular unless otherwise specified.
Inch bores and keyway tolerances conform to ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, check with Engineering Section.
Bigger sizes can be found, please check with Technical Support.